F 150 4WD V8-4.6L VIN 8 (2010)
4. NOTE: The selector lever bezel has been removed for clarity. Do not remove the selector lever bezel.
Remove the 4 selector lever assembly bolts.
5. Disconnect the selector lever cable from the selector lever cable bracket.
6. Disconnect the selector lever harness connector and remove the selector lever from the vehicle.
Installation
1. NOTE: When installing the selector lever cable, make sure that the selector lever cable locking tabs are locked in place. Press the selector lever
cable into the bracket and listen for the selector lever cable to click in place. Pull back on the selector lever cable to make sure that it is locked into
the bracket.
Install the selector lever cable in the selector lever cable bracket.
2. Position the selector lever assembly in the console and install the 4 bolts.
-
Tighten to 8 Nm (71 lb-in).