F 150 4WD V8-4.6L VIN 8 (2010)
10. NOTE: LH shown, RH similar.
Remove the LH and RH exhaust heat shield bolt from the transmission crossmember.
11. NOTE: Index-mark the driveshaft to maintain initial driveshaft balance for installation.
Remove the front driveshaft.
12. Remove the 2 transmission insulator and retainer nuts.
13. Remove the isolator bolt and cap.
14. NOTE: Right side shown, left side similar. Transmission support crossmember removed for clarity.
Remove the 4 transmission insulator and retainer bolts.
15. Support the transfer case.