F 150 4WD V8-4.6L VIN 8 (2010)
2. If equipped, remove the 10 bolts and the forward and rearward skid plates.
-
To install, tighten to 48 Nm (35 lb-ft).
3. Index-mark the front flange to the pinion flange.
4. Index-mark the rear flange to the transfer case flange.
5. Remove and discard the 6 rear flange-to-transfer case flange bolts and 3 washers.
-
To install, tighten to 55 Nm (41 lb-ft).
6. Remove and discard the 6 front flange-to-pinion flange bolts and 2 washers.
-
To install, tighten to 55 Nm (41 lb-ft).
7. Remove and discard the 4 stabilizer bar bracket nuts and allow the stabilizer bar to swing downward.
-
To install, tighten to 55 Nm (41 lb-ft).
8. Remove the front driveshaft.
9. To install, reverse the removal procedure.
Driveshaft - Rear, One-Piece