F 150 4WD V8-4.6L VIN 8 (2010)
5. Set the driveshaft assembled length to specification.
1. Remove any excess grease from the slip-yoke boot and driveshaft slip-yoke surfaces.
2. Position the slip-yoke boot in the slip-yoke boot groove.
3. Set the driveshaft assembled length to specification.
-
Measure from the stub shaft weld to the U-joint centerline.
4. Bleed the air from the slip-yoke boot.
6. Using the Keystone Clamp Installer, crimp the large driveshaft slip-yoke boot clamp.
7. Install the driveshaft. For additional information, refer to Driveshaft - Front See: Driveshaft - Front or Driveshaft - Rear, Two-Piece See:
Driveshaft - Rear, Two-Piece.