F 150 4WD V8-4.6L VIN 8 (2010)
12. Remove the IWE disconnect from the outboard CV joint housing.
13. Using the Halfshaft Remover and Slide Hammer, remove the halfshaft from the differential and the intermediate shaft.
14. Remove and discard the circlip and the stub shaft seal. For additional information, refer to Differential Assembly.
15. NOTICE: Verify the spline engagement by checking for spline lash before installing the halfshaft nut or component damage may occur.
To install, reverse the removal procedure.
Rear Drive Axle/Differential - Ford 8.8-Inch Ring Gear
Axle Shaft
