F 150 4WD V8-4.6L VIN 8 (2010)
8. NOTE: Do not damage the wheel bearing oil seal.
Remove the axle shaft.
Installation
1. Lubricate the lip of the wheel bearing oil seal with grease.
2. NOTE: Do not damage the wheel bearing oil seal.
Install the axle shaft.
3. NOTE: Do not damage the rubber O-ring in the U-washer groove.
Install the U-washer.
1. Position the U-washer on the button end of the axle shaft.
2. Pull the axle shaft outward.
4. Install the differential pinion shaft.
-
Align the bolt hole in the differential pinion shaft with the bolt hole in the case.
-
Install the new pinion shaft lock bolt.
-
Tighten to 30 Nm (22 lb-ft).