F 150 4WD V8-4.6L VIN 8 (2010)
19. NOTE: Tighten the through-bolt until the tool is in the closed position.
Using the Constant Velocity Joint Boot Clamp Installer, install the 2 boot clamps.
20. NOTE: Maintain a clean work surface.
Compress the Integrated Wheel End (IWE) disconnect on the bench to collapse the vacuum chamber.
21. While the IWE disconnect is collapsed, install a vacuum cap on the vacuum port.
22. NOTICE: Do not install the Integrated Wheel End (IWE) end disconnect in the knuckle. It must be installed on the outer Constant
Velocity (CV) joint housing or damage to the component may occur.
Install the IWE disconnect on the outer CV joint housing.
23. NOTICE: Verify the spline engagement by checking for spline lash before installing the halfshaft nut or damage to the component may
occur.
Install the halfshaft in the vehicle. For additional information, refer to Halfshaft See: Removal and Replacement/Front Drive Halfshafts in the
Removal and Installation.