F 150 4WD V8-4.6L VIN 8 (2010)
Installation
1. Align the motor gear splines onto the drum and press the motor into place, making sure there is correct alignment of the attachment bolt holes.
-
Install the 3 bolts attaching the steel bracket to the plastic cable housing.
2. Install the rear window glass regulator and motor assembly screws.
-
Tighten to 11 Nm (97 lb-in).
3. Connect the rear window glass motor electrical connector.
4. Install the rear trim panel and the pin-type retainers.
5. For SuperCab and SuperCrew, install the rear corner trim panels.
-
For SuperCab, install the B-pillar trim panels.
-
For SuperCrew, install the C-pillar trim panels.