F 150 4WD V8-5.4L Flex Fuel (2008)
Wheel Speed Sensor: Service and Repair
Rear
Wheel Speed Sensor - Rear
Wheel Speed Sensor - Rear
Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Maintenance/Service and Repair.
2. Disconnect the wheel speed sensor electrical connector.
3. Remove the wheel speed sensor bolt.
^
To install, tighten to 15 Nm (11 lb-ft).
4. NOTE: Install a new O-ring before installing the rear axle speed sensor.
Remove the wheel speed sensor.
5. To install, reverse the removal procedure.
