F 150 4WD V8-5.4L Flex Fuel (2008)
adhesive bond.
Using the alignment marks made previously, position the windshield glass on the pinch weld.
12. NOTE: The urethane adhesive must cure for a minimum of one hour before testing for air or water leaks.
After the urethane has cured, check the windshield glass seal for air or water leaks through the urethane adhesive bead and add urethane adhesive
as necessary.
13. Install the Y-clips.
-
Each Y-clip snaps into a slot on the bottom of the roof ditch moulding.
14. Install the roof ditch mouldings.
15. Install the cowl panel grille.
16. Raise the front portion of the headliner near the windshield upper opening and install.
17. Install the interior rear view mirror.
18. Install the RH and LH side A-pillar trim panels, sun visors, retainers and, if equipped, overhead console.
