F 150 4WD Pickup L6-300 4.9L (1983)
Figure 20
2.
Moving toward the front of the vehicle, approximately 17 inches from the existing dash panel grommet, carefully cut away about 3 inches of
wiring wrap to expose the Yellow 10 gauge wire (#37 circuit). Cut the Yellow 10 gauge (#37 circuit) wire at this point to terminate the feed
circuit. Fold back the cut end of the wire which goes inside the vehicle and tape wrap with pressure-sensitive waterproof tape (D6AZ-19627-A), as
shown in Figure 20, View B.
3.
Repeat Steps 3 through 9 of the procedure for 1986 model units.
PART NUMBER
PART NAME
CLASS
WB-310-B
10 Gauge Wire (Black)
C
E6FZ-14488-C
Butt Splice Connector
B