F 150 4WD Pickup V8-281 4.6L VIN W EFI (1997)
NOTE: Manual shift lever must be in the neutral position.
7. Tighten the DTR or TR sensor bolts and remove the Digital Transmission Range (DTR) Sensor Alignment Tool.
8. Install the manual control lever.
(1) Position the manual control lever.
(2) Install a new manual lever shaft outer nut.
9. With manual lever in overdrive, connect the shift control cable.
10. Install TR or DTR sensor electrical connector.
11. Install the filter and transmission fluid pan.
12. Install the front driveshaft.
(1) Position the front driveshaft.
(2) Install the eight front driveshaft bolts (four each end).
13. Lower the vehicle.
