F 150 4WD Pickup V8-4.6L VIN W (2006)
occurring, possibly causing a fire or explosion if fuel vapor or liquid fuel are present in the area. Failure to follow these instructions can result in
personal injury.
-
Do not smoke or carry lighted tobacco or open flame of any type when working on or near any fuel-related component. Highly flammable mixtures
are always present and may be ignited. Failure to follow these instructions may result in personal injury.
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Disconnect the battery ground cable.
3. NOTE: The evaporative emission (EVAP) canister assembly is located above the spare tire.
Remove the spare tire.
4. Disconnect the fuel vapor tube quick connect coupling.
5. Disconnect the fuel vapor hose.
6. Remove the 2 front EVAP canister assembly bracket bolts.
-
To install, tighten to 13 Nm (10 lb-ft).
7. Remove the 2 outer rear EVAP canister assembly bracket bolts.
-
To install, tighten to 20 Nm (15 lb-ft).
8. Remove the 2 inner rear EVAP canister assembly bracket bolts.
-
To install, tighten to 13 Nm (10 lb-ft).
