F 150 4WD Pickup V8-5.4L CNG VIN M (2001)
2. Trim the remaining urethane on the pinch weld to within specification.
^
The old urethane surface should be smooth and free of cuts and contamination.
CAUTION: Care must be taken to avoid scratching the pinch weld.
3. Use a wool applicator to apply Urethane Metal Primer Essex U-413 meeting Ford specification WSB-M2G234-C to any exposed metal on the
pinch weld. Allow six to ten minutes to dry.
4. Apply a foam dam meeting Ford specification WSB-M2G234-C to the pinch weld.
5. If reinstalling the original windshield, remove the excess urethane adhesive from the windshield glass.
6. If installing a new windshield glass, clean the inside of the glass surface with an alcohol-free cleaner to make sure the ceramic-coated area is clean.
7. If installing a new windshield, apply Urethane Glass Prep Essex U-401 meeting Ford specification WSB-M2G314-B twice around the glass
surface to be prepped.
CAUTION: Wipe off the Urethane Glass Prep immediately after each application because it flash dries.
NOTE: Apply with deliberate strokes, making sure not to overlap the applied area.
8. If installing a new windshield, apply Urethane Glass Primer Essex U-402 meeting Ford specification WSB-M5B280-C to the same area that was in
the previous step. Allow five minutes to dry.
9. Cut the urethane applicator tip to specification.
