F 150 4WD Pickup V8-5.4L VIN V Flex Fuel (2006)
fuel-related component. Highly flammable mixtures are always present and can be ignited. Failure to follow these instructions may result in
personal injury.
CAUTION:
-
If the liquid or vapor tube is damaged (torn, holes or delaminated), a new tube assembly must be installed. Do not use aftermarket
sleeving. Do not re-adhere loose sleeving material.
-
When reusing liquid or vapor tube connectors, make sure to use compressed air to remove any foreign material from the connector
retaining clip area before separating from the tube. Apply clean engine oil to the end of the tube before inserting the tube into the
connector.
-
Fuel injection equipment is manufactured to very precise tolerances and fine clearances. It is, therefore, essential that absolute cleanliness
is observed when working with these components. Always install blanking plugs to any open orifices or tubes.
-
Do not use any tools. The use of tools may cause a deformity in the clip components which may cause fuel leaks.
1. Release the fuel system pressure.
2. Disconnect the battery ground cable.
3. Release the locking tab on the coupling.
4. Separate the coupling from the fitting.
Connect - Type III
1. CAUTION: Make sure the fuel tube clicks into place when installing the tube. To make sure that the fuel tube is fully seated, pull on the
tube.
NOTE: Apply clean engine oil to O-ring seals.
Release the locking tab and install the coupling onto the fitting.