F 150 4WD Pickup V8-5.4L VIN V Flex Fuel (2006)
Seat Belt Buckle: Service and Repair
Safety Belt Buckle - Rear
SAFETY BELT BUCKLE - REAR
Removal and Installation
WARNING: All safety belt assemblies (including retractors, belt tension sensor [BTS] if equipped, buckles, shoulder belt height adjusters [if
equipped], child safety seat tether attachments and attaching hardware) should be inspected after every collision. All new belt assemblies
should be installed unless a qualified technician finds the assemblies show no damage and operate correctly. Belt assemblies not in use during a
collision should also be inspected and new assemblies installed if either damage or incorrect operation is noted. Failure to follow these
instructions could increase the risk of injury in collisions.
1. Remove the rear seat backrest.
2. Remove the nut and the RH and center safety belt buckle assembly.
-
To install, tighten to 80 Nm (59 lb-ft).
3. NOTE: The LH safety belt buckle is attached to the rear center safety belt retractor assembly.
Remove the rear center safety belt retractor assembly.