F 150 4WD Pickup V8-5.4L VIN V Flex Fuel (2006)
2. With the vehicle in NEUTRAL, position it on a hoist.
3. NOTE: The harness connector is located in the engine compartment secured to the fender apron.
Disconnect the wheel speed sensor electrical connector.
4. Disconnect the 4 wheel speed sensor harness retainers.
5. CAUTION: Do not allow the brake caliper to hang from the brake hose or damage to the hose can occur.
Remove the 2 brake caliper anchor plate bolts and position the brake caliper, pads and anchor plate aside.
^
Support the brake caliper, pads and anchor plate using mechanic's wire.
^
To install, tighten to 112 Nm (83 ft. lbs.).
6. NOTE: Index-mark the brake disc and wheel hub flange before removing the brake disc.
Remove the brake disc.
7. Remove the bolt and the wheel speed sensor.
^
To install, tighten to 8 Nm (71 inch lbs.).
8. To install, reverse the removal procedure.