F 150 Heritage 2WD Pickup V8-4.6L SOHC VIN W (2004)
10. Disconnect the Camshaft Position (CMP) sensor.
11. Disconnect the LH radio interference capacitor.
12. Lift the engine control wiring harness off of the valve cover studs.
13. NOTE: The intake manifold is removed for clarity.
NOTE: The bolts are part of the valve cover and should not be removed.
Remove the LH valve cover.
^
Fully loosen the bolts and remove the valve cover.
^
Clean the valve cover mating surface of the cylinder head with silicone gasket remover and metal surface prep. Follow the directions on the
packaging.
^
Inspect the valve cover gasket. If the gasket is damaged, remove and discard the gasket. Clean the valve cover gasket groove with soap and
water or a suitable solvent.
Installation