F 150 Heritage 2WD Pickup V8-4.6L SOHC VIN W (2004)
![background image](/ford/f_150_heritage_2wd_pickup/v8-4.6l_sohc_vin_w/Page-1940008.png)
7. Tighten the special tool to the specified rotational torque.
8. NOTE: The special tool must be offset to obtain an accurate reading.
Rotate the special tool several half-turns to make sure of correct seating of the pinion bearings, then position the special tool.
9. Install the special tool.
1
Position the special tool.
2
Install the differential side bearing caps.
3
Install the differential side bearing cap bolts.
10. NOTE: Drive pinion bearing adjustment shims must be flat and clean.
NOTE: A slight drag should be felt for correct shim selection. Do not attempt to force the pinion shim between the Gauge Block and the Gauge
Tube. This will minimize selection of a pinion shim thicker than required, which results in a deep tooth contact in the final assembly of integral