F 150 Heritage 2WD Pickup V8-5.4L SOHC VIN 3 (2004)
![background image](/ford/f_150_heritage_2wd_pickup/v8-5.4l_sohc_vin_3/Page-1994001.png)
Center Support: Service and Repair
Driveshaft Center Bearing
Special Tool(s)
Disassembly
1. Remove the driveshaft from the vehicle.
2. CAUTION: Do not, under any circumstance, clamp the driveshaft or the coupling shaft in the jaws of a vise or similar holding fixture. Denting or
localizing fracture can result, causing driveshaft failure during vehicle operation.
Place the driveshaft assembly on a suitable workbench. Do not to damage the tubes.
3. Remove the driveshaft slip-yoke from the coupling shaft.
1
Cut and discard the driveshaft slip-yoke boot clamps.
2
Remove the driveshaft slip-yoke from the coupling shaft.
4. Remove the slip-yoke boot from the coupling shaft.
^
Inspect the boot for damage. Discard the hoot as necessary.
5. Inspect the lubricant on the coupling shaft splines and in the driveshaft slip-yoke for contamination. If contaminated, inspect the coupling shaft
splines and the driveshaft slip-yoke wear. Install new components as necessary.