F 150 Heritage 4WD Pickup V6-4.2L VIN 2 (2004)
2. NOTE: The output shaft and the driveshaft are a balanced assembly.
Install the driveshaft.
^
Align all the index marks and position the driveshaft on the transmission.
^
Install the driveshaft.
3. NOTE: To maintain driveshaft balance, install the driveshaft yoke and flange in the original position that was marked during removal.
Install the four retaining bolts.
4. Check the level of the transmission fluid, add clean automatic transmission fluid as necessary.
Extension Housing Gasket
Extension Housing Gasket
Material
Material
Removal
All vehicles
1. With the vehicle in NEUTRAL, position it on a hoist.
2. NOTE: To maintain initial driveshaft balance, mark the rear driveshaft yoke and axle flange so they may be installed in their original positions.
Mark the driveshaft flange and the rear pinion flange for correct alignment during assembly.