F 150 Heritage 4WD Pickup V8-5.4L CNG VIN M (2004)
Wheel Speed Sensor: Service and Repair
Sensor, Rear
Sensor - Rear
Removal and Installation
1. Raise and support vehicle. For additional information, refer to Maintenance/Service and Repair.
2. NOTE: Clean off dirt and debris that may have collected around the rear anti-lock brake sensor before removal.
Remove the rear anti-lock brake sensor.
1
Disconnect the rear anti-lock brake sensor electrical connector.
2
Remove the bolt.
3
Remove the rear anti-lock brake sensor.
3. NOTE: Thoroughly clean the mounting surface.
NOTE: Inspect the anti-lock brake sensor O-ring for damage; lightly lubricate the O-ring with SAE-75W-140 High Performance Rear Axle
Lubricant FITZ-19580-B or equivalent meeting Ford specification WSL-M2CI92-A.
To install, reverse the removal procedure.
