F 150 Super Crew 4WD V8-5.4L Prop SOHC VIN Z (2003)
![background image](/ford/f_150_super_crew_4wd/v8-5.4l_prop_sohc_vin_z/Page-1845009.png)
9. Install the special tool.
1
Position the special tool.
2
Install the differential side bearing caps.
3
Install the differential side bearing cap bolts.
10. NOTE: Drive pinion bearing adjustment shims must be flat and clean.
NOTE: A slight drag should be felt for correct shim selection. Do not attempt to force the pinion shim between the special tools. This will
minimize selection of a pinion shim thicker than required, which results in a deep tooth contact in the final assembly of integral rear axle
assemblies.
Use a drive pinion bearing adjustment shim as a gauge for shim selection.
^
After the correct shim thickness has been determined, remove the special tools from the rear axle housing.
11. Using a press and the special tools, press the pinion bearing until it is firmly seated on the pinion and pinion shim.