F 250 2WD HD Pickup V8-7.3L DSL Turbo VIN F (1997)
c. Snap the retaining clip over the rocker arm pedestal groove.
2. Lubricate the push rod ends with engine oil and install the push rod (copper end up).
3. Rotate the engine until the mark on the crankshaft damper is at 11 o'clock to prevent valve damage when installing the intake rocker arm and
exhaust rocker arm.
CAUTION: Failure to follow the next step of this procedure could result in bent valves causing severe engine damage.
4. Install the push rods.
5. Install the intake rocker arm or exhaust rocker arm.
6. Install the two rocker arm bolts. Tighten rocker arm bolts evenly to 27 Nm (20 ft. lbs.).