F 250 2WD LD Pickup V8-5.4L SOHC VIN L (1997)
10. Using a feeler gauge, check the stack-up clearance in three places, 120 degrees apart.
-
If the clearance is not to specification, install the correct selective forward clutch pressure plate retaining ring and recheck the clearance.
11. Install the No. 8B forward clutch needle bearing.
NOTE:
-
Lightly lubricate the needle bearing with petroleum jelly to hold it in place during assembly.
-
The bearing large inner diameter radius must face inward.
12. Install the two new cast iron forward clutch cylinder seals in the grooves.
NOTE: Stagger the interlocking opening on the seals 180 degrees apart.
13. Install the No. 9A forward clutch thrust bearing.
NOTE:
-
Lightly lubricate the thrust bearing with petroleum jelly to hold it in place during assembly.
-
The black side of the bearing must face upward.