F 250 2WD Pickup V6-4.2L VIN 2 (1998)
Air Bag: Description and Operation
Driver Air Bag Module
The driver air bag module:
^
is replaced as an assembly.
^
is mounted in the center of the steering wheel.
Steering Wheel Trim Cover
The steering wheel trim cover:
^
encases the driver air bag module and horn switch.
^
has tear seams that separate to allow inflation of the air bag.
^
must not be repainted for any reason.
^
is a component of the driver air bag module and is not repaired separately.
Air Bag
The air bag:
^
is constructed of nylon.
^
is a component of the driver air bag module and is not replaced separately.
Inflator
The inflator:
^
receives electrical energy when the air bag sensors close.
^
contains an igniter that converts the electrical signal to thermal energy (heat), causing the ignition of the inflator gas generant.
^
inflates the air bag with nitrogen gas after the chemical reaction takes place.
^
is a component of the driver air bag module and is not replaced separately.
Mounting Plate and Retainer Ring
The mounting plate and retainer ring:
^
attach and seal the air bag to the inflator.
^
attach the trim cover.
^
mount the entire driver air bag module to the steering wheel.
^
are components of the driver air bag module and are not replaced separately.
Air Bag Sliding Contact
The air bag sliding contact:
^
is mounted on the steering column tube, behind the steering wheel.
^
continuously transfers electrical signals from the driver air bag module to the air bag sensors.
