F 250 2WD Pickup V8-5.4L CNG VIN M (1999)
Seat Belt: Service and Repair
Removal and Installation
Rear Seat, Center Passenger
Safety Belt Bolt Bit
Special Tool(s)
REMOVAL
1. Open the 60% and 40% rear seat cushions.
2. Remove the rear seat center occupant safety belt tongue assembly.
1
Use the special tool to remove the bolt.
2
Remove the rear seat center occupant safety belt tongue assembly by pulling the anchor up through the elastic strap on the seat back.
INSTALLATION
1. To install, reverse the removal procedure.
-
Check the restraint system for normal operation.
NOTE: Make sure that safety belt webbing is not twisted prior to installation.
60/40 Split and Front Bench Seat, Center Passenger