F 250 2WD Pickup V8-5.4L CNG VIN M (1999)
8. Remove the solenoid valve.
Installation
1. NOTE: Be sure the new air spring solenoid is fully seated into both stages of the air spring.
NOTE: Check the solenoid valve O-rings for abrasion or cuts. Replace O-rings as required using air spring connector repair kit.
NOTE: Lightly apply Silicone Brake Caliper Grease and Dielectric Compound D7AZ-19A331-A or equivalent meeting Ford specification
ESE-M1C171-A to the O-rings.
NOTE: After installing the solenoid, it Is necessary to inflate the air suspension system.
NOTE: When installing the air lines, make sure the white air line is fully inserted into the fitting for correct installation.
To install, reverse the removal procedure.