F 250 2WD Pickup V8-5.4L CNG VIN M (1999)
3. NOTE: The length of the rod attached to the piston is graded for three different lengths. Therefore, they should not be installed in any
transmission other than the transmission from which they were removed.
Remove the (A) reverse band servo cover, (B) reverse band servo piston and rod and (C) reverse band servo spring.
Installation
NOTE: This is not an ordinary installation procedure and does not compensate for band wear.
1. NOTE: Lubricate the reverse piston seal to facilitate assembly and prevent damage to the seal.
Install the reverse servo piston and return spring.
-
Do not install the piston cover.
2. Install the Servo Piston Selection Tool and tighten the band apply bolt.
3. Attach the Dial Indicator With Bracketry.