F 250 2WD Pickup V8-5.4L CNG VIN M (1999)
2. NOTE: Prior to installation, lightly lubricate the gerotor gears with clean Motorcraft MERCON or MERCON V (ATF) Transmission Fluid or
equivalent Meeting FORD specification.
Install the (A) gerotor gearset, with the (B) dot facing the control body assembly.
3. CAUTION: Prior to pump assembly, make sure all cup plugs are installed.
CAUTION: Inspect mating surfaces of the pump body and the control body to make sure they are clean and free of nicks and burrs.
Lower the (A) control body and stator assembly onto the (B) pump body, aligning the (C) 28 mm hole in each body.
4. NOTE: Make sure that the outer edges of the pump body and the outer bolt holes are aligned during assembly.
Using the special tool, assemble the pump and loosely install 11 bolts.
1
Install the 10mm alignment bolt.
2
Tighten the bolts.