F 250 2WD Pickup V8-5.4L CNG VIN M (1999)
6. NOTE: The Gauge Block must be offset to obtain an accurate reading.
Rotate the Gauge Block several half-turns to ensure proper seating of the pinion bearings, and position the Gauge Block.
7. Install the Gauge Tube.
1
Position the Gauge Tube.
2
Install the differential side bearing caps.
3
Install the differential side bearing cap bolts.
8. NOTE: Drive pinion bearing adjustment shims must be flat and clean.
NOTE: A slight drag should be felt for correct shim selection. Do not attempt to force the pinion shim between the Gauge Block and the Gauge
Tube. This will minimize selection of a pinion shim thicker than required, which results in a deep tooth contact in the final assembly of integral
rear axle assemblies.
Use a drive pinion bearing adjustment shim as a gauge for shim selection.
-
After the proper shim thickness has been determined, remove the Gauge Tube.