F 250 2WD Pickup V8-5.4L CNG VIN M (1999)
2. NOTE: Use the yellow snap rings supplied in the kit to assemble the universal joint (U-joint). If difficulty is encountered with the yellow snap
rings, install the black snap rings.
Remove the driveshaft from the U-joint Tool, and install the snap ring.
3. Repeat Steps 1 and 2 to install the opposite side of the driveshaft yoke.
4. Inspect the driveshaft slip-yoke. Install a new yoke, if necessary.
5. Repeat Steps 1 and 2 to install the remaining new bearing cups, spider, driveshaft slip-yoke, and the snap rings.
6. NOTE: Do not strike the bearings.
Check the U-joints for freedom of movement.
-
If binding, strike the yoke with a brass or plastic hammer.
7. Install the driveshaft.
