F 250 2WD Pickup V8-7.3L DSL (1990)
Cruise Control Servo: Customer Interest
Speed Control - Intermittent or Inoperative
Article No.
92-7-8
03/25/92
^
SPEED CONTROL - INTERMITTENT OR INOPERATIVE - DURING WET WEATHER CONDITIONS
^
WIRING - SPEED CONTROL INTERMITTENT OR INOPERATIVE - CONNECTOR CORROSION
LIGHT TRUCK:
1986-90 BRONCO II
1986-91 BRONCO, ECONOLINE, F-150-350 SERIES, RANGER
1991 EXPLORER
This TSB article is being republished in its entirety to correct the grease part number suffix which appeared in Step 5 of the service procedure.
ISSUE:
Intermittent or inoperative speed control operation may occur during wet weather operation. This may be caused by a corroded connector at
the servo.
ACTION: Inspect the connector at the servo for corrosion to determine if replacement is required. Refer to the following procedure for service details.
1.
Disconnect the connector at the servo.
2.
Blow dry the connector assembly with shop air.
3.
Clean and inspect pins for corrosion.
4.
Replace any damaged or corroded pins (D1AZ-14488-E).
5.
Apply grease (F2AZ-19584-A) to both ends of the connector to prevent water entry.
6.
Reconnect the connector at the servo.
PART NUMBER
PART NAME
CLASS
F2AZ-19684-A
Grease
C
D1AZ-14488-E
Pin Connector
C
SUPERSEDES:
92-1-7
WARRANTY STATUS: Eligible Under Basic Warranty
Coverage
OPERATION DESCRIPTION
TIME
920708A
Clean And
Inspect Pins And
0.3 Hr.
Apply Grease To
Connectors
920708B
Clean And Inspect Pins
0.4 Hr.
Replace Damaged Pins As
Necessary, Apply Grease
To Connectors
DEALER CODING
BASIC PART NO.
CONDITION CODE
14488
84
OASIS CODES:
203300, 205000