F 250 2WD Pickup V8-7.3L DSL (1990)
Vehicle Speed Sensor/Transducer - Cruise Control: Testing and Inspection
1.
Disconnect 6 way connector from amplifier assembly, then connect an ohmmeter between dark green/white and black wires on Bronco and
F-Series or dark green and black wires on E-Series at the speed sensor end. A reading of 200 ohms should be obtained. A reading of 0 ohms
indicates a shorted coil and an infinity reading indicates an open coil.
2.
Replace sensor if a correct reading has not been obtained.