F 250 2WD Pickup V8-7.3L DSL (1990)
Clutch Pedal Assembly: Service and Repair
Clutch Pedal
Removal
1. Disconnect the clutch pedal retracting spring from the clutch pedal and bracket.
2. Remove the nut that retains the clutch pedal to the shaft and remove the clutch pedal.
Installation
1. Position the clutch pedal on the shaft and install and tighten the nut.
2. Install the retracting spring. Make sure the spring engages the slots in the pedal and bracket.
NOTE: Spring installation is easier if the spring is first compressed in a vise and retained in a compressed state with mechanics wire until it is in place.
Once in place cut the mechanics wire and remove.
