F 250 2WD Pickup V8-7.3L DSL Turbo VIN F (1994)
tighten to specification.
Note: Priming the lubricating system will minimize the possibility of scuffing or heat build-up during initial engine operation, which could lead to
immediate or low mileage failure.
5. Prime the entire engine lubricating system to fill the oil cooler, oil filter and cylinder block galleries with the specified type and grade of oil.
6. Lower vehicle.
7. Install turbocharger assembly.
8. Check the engine oil level and fill as necessary with the specified type and grade of oil.
9. Fill and bleed the cooling system.
Caution: Left-hand thread. Turn nut counterclockwise to tighten.
10. Install fan and clutch assembly using Fan Clutch Pulley Holder T83T-6312-A and Fan Clutch Nut Wrench T83T-6312-B. Tighten nut to
54-163 Nm (40-120 ft-lb).
11. Install radiator fan shroud.
12. Connect ground cables at both batteries.
13. Run engine and check for oil and coolant leaks.