F 250 2WD Pickup V8-7.3L DSL Turbo VIN F (1994)
b.
Check the travel of the rack when the temperature knob is rotated to the full cold position. The notch in the rack should stop at the bullet
connector bracket when rotated to cold. Refer to Figure 5. If it does not come within 1 mm or touch the bracket, replace the control
assembly (F2TZ-19980-A).
c.
Reattach the cable and verify that the door closes at both ends of its travel.
7.
On 1994 vehicles, verify that the temperature door closes at both ends of its travel. If the door does not close properly, replace the temperature
control cable (F4TZ-18518-A).
a.
Adjust the cable if necessary and verify that the door operates properly.
CABLE REMOVAL
NOTE:
THE ADJUSTMENT CLIP IS ATTACHED TO A MOLDED-IN BRACKET LOCATED IN THE UPPER LEFT HAND AREA OF THE
HEATER CORE ACCESS COVER. THE CLIP IS RETAINED BY TWO (2) TABS. THE HEATER-A/C TEMPERATURE CABLE CLIP
REMOVER (D91T-18532-A, OR EQUIVALENT) IS REQUIRED TO DEPRESS THE LOCKING TABS IN ORDER TO ALLOW FOR
REMOVAL FROM THE ATTACHING BRACKET.
1.
Open the glove box door to gain access to the adjustment clip.