F 250 2WD Super Duty V10-6.8L (2009)
Disassembly and Assembly
1. Remove the rear seat. For additional information, refer to Seat - Rear, Crew Cab, Bench Seat See: Service and Repair/Rear Seats/Seat - Rear,
Crew Cab, Bench Seat.
2. Remove the seat backrest. For additional information, refer to Seat Backrest - Rear, Crew Cab, Bench Seat See: Seat Back/Service and
Repair/Removal and Replacement/Rear Seats/Seat Backrest - Rear, Crew Cab, Bench Seat.
3. Remove the 4 riser-to-spacer nuts and LH and RH risers.
-
To install, tighten to 50 Nm (37 lb-ft).
4. Remove 4 spacer-to-cushion frame bolts and spacers.
-
To install, tighten to 50 Nm (37 lb-ft).
5. Release the cushion trim cover J-clips attached to the cushion frame and remove the cushion trim cover and cushion foam pad.
6. Invert the cushion trim cover, remove the 2 rows of hog rings and separate the cushion trim cover from the cushion foam pad.
7. To assemble, reverse the disassembly procedure.
Seat Cushion - Rear, Crew Cab, Bucket Seat
Seat Cushion - Rear, Crew Cab, Bucket Seat
Crew Cab Bucket Seat Cushion
NOTE: LH shown, RH similar.