F 250 2WD Super Duty V10-6.8L (2009)
Seat Latch: Service and Repair
Seat Latch - Rear, SuperCab
Seat Latch - Rear, SuperCab
Removal and Installation
NOTE: If both latches need to be removed, repeat steps for other side.
1. Remove the seat cushion. For additional information, refer to Seat - Rear, SuperCab See: Service and Repair/Rear Seats/Seat - Rear, SuperCab.
2. Remove the support-to-latch bolts.
1. Remove the upper support-to-latch bolt.
-
To install, tighten to 33 Nm (24 lb-ft).
2. Remove the lower support-to-latch bolt.
-
To install, tighten to 25 Nm (18 lb-ft).
3. Remove the latch cover.
4. Remove the latch-to-cushion frame bolt and latch.
-
To install, tighten to 50 Nm (37 lb-ft).
5. To install, reverse the removal procedure.
