F 250 2WD Super Duty V10-6.8L (2009)
-
To install (F-250, F-350), tighten the new bolts to 225 Nm (166 lb-ft).
-
To install (F-450, F-550), tighten the new bolts to 400 Nm (295 lb-ft).
3. Inspect the brake caliper anchor plate assembly.
-
Check the guide pin boots for damage and replace as necessary.
-
Check the guide pins for binding and damage.
-
If pins are worn or damaged, install new pins. Lubricate the pins with silicone grease.
4. To install, reverse the removal procedure.
Brake Caliper
Brake Caliper - F-250, F-350
Removal and Installation
WARNING: Do not use any fluid other than clean brake fluid meeting manufacturer's specification. Additionally, do not use brake fluid that
has been previously drained. Following these instructions will help prevent system contamination, brake component damage and the risk of
serious personal injury.
WARNING: Carefully read cautionary information on product label. For EMERGENCY MEDICAL INFORMATION seek medical advice.
For additional information, consult the product Material Safety Data Sheet (MSDS) if available. Failure to follow these instructions may result
in serious personal injury.
NOTICE: Brake fluid is harmful to painted and plastic surfaces. If brake fluid is spilled onto a painted or plastic surface, immediately wash it
with water.
