F 250 2WD Super Duty V10-6.8L (2009)
1. For additional information, refer to the procedures.
Hydraulic Lash Adjuster
Hydraulic Lash Adjuster
Removal and Installation
1. Remove the camshafts. For additional information, refer to Camshaft - RH See: Camshaft/Service and Repair/Removal and
Replacement/Camshaft - RH or Camshaft - LH See: Camshaft/Service and Repair/Removal and Replacement/Camshaft - LH.
2. Remove the remaining roller followers from the cylinder head being serviced.
3. NOTICE: If the components are to be reinstalled, they must be installed in their original locations, or engine damage may occur. Mark
the components for installation into their original locations.
Remove the hydraulic lash adjusters that are being serviced.
4. Inspect the hydraulic lash adjusters.
5. NOTE: Lubricate each of the hydraulic lash adjusters with clean engine oil prior to installation.
To install, reverse the removal procedure.