F 250 2WD Super Duty V10-6.8L (2009)
1. For additional information, refer to the procedures.
Valve Springs
Valve Springs
Removal
All valve springs
1. Depending on the valve being serviced, remove the LH or RH valve cover. For additional information, refer to Valve Cover - LH See: Valve
Cover/Service and Repair/Valve Cover - LH or Valve Cover - RH See: Valve Cover/Service and Repair/Valve Cover - RH.
2. Remove the spark plug.
3. Rotate the crankshaft until the piston for the valve being serviced is at the top of its stroke with the intake valve and the exhaust valves closed.
Cylinder No. 7 front intake valve spring
4. NOTICE: The balance shaft bearing caps must be installed in their original locations or engine damage may occur. Record camshaft
bearing cap locations.
Remove the 6 bolts in the sequence shown, the 3 bearing caps and the balance shaft.
5. Remove the 2 bolts and the camshaft bearing cap.
Cylinder No.10 front intake valve spring
