F 250 2WD Super Duty V10-6.8L (2009)
25. Connect the fuel tube bracket and install the nut.
-
Tighten to 12 Nm (106 lb-in).
26. Install the 2 rear transmission insulator nuts.
-
Tighten to 115 Nm (85 lb-ft).
All vehicles
27. Position the transmission auxiliary fluid cooler tube support bracket and the starter wiring harness support bracket onto the engine front cover stud
bolt and install the nut.
-
Tighten to 25 Nm (18 lb-ft).
28. If equipped, position the engine oil cooler and install the threaded insert.
-
Tighten to 58 Nm (43 lb-ft).
29. Install a new oil filter.
-
Tighten to 16 Nm (142 lb-in).
30. Install the TB spacer.
31. Install the engine cooling fan.
32. Install the generator.
33. Fill the crankcase with clean engine oil.
