F 250 2WD Super Duty V10-6.8L (2009)
11. Lubricate the balance shaft journals with clean engine oil.
12. NOTE: Camshaft sprocket removed from art for clarity.
NOTE: It may be necessary to rotate the crankshaft to align the balance shaft timing marks.
Position the balance shaft on the journals and align the timing mark on the balance shaft with the camshaft timing mark as shown.
13. NOTICE: The balance shaft bearing caps must be installed into their original locations or engine damage may occur.
Position the 3 balance shaft bearing caps and install the 6 bolts and tighten in the sequence shown.
-
Tighten to 10 Nm (89 lb-in).
All valve seals
14. Install the spark plug.
15. Depending on the valve being serviced, install the LH or RH valve cover. For additional information, refer to Valve Cover - LH See: Cylinder
Head Assembly/Valve Cover/Service and Repair/Valve Cover - LH or Valve Cover - RH See: Cylinder Head Assembly/Valve Cover/Service and
Repair/Valve Cover - RH.