F 250 2WD Super Duty V10-6.8L (2009)
Air Door Actuator / Motor: Service and Repair
Temperature Blend Door Actuator - LH
Temperature Blend Door Actuator - LH
Removal and Installation
1. Remove the heater core and evaporator core housing. For additional information, refer to Heater Core And Evaporator Core Housing See:
Housing Assembly HVAC/Service and Repair.
2. Remove the floor duct screw.
3. Remove the floor duct.
4. Disconnect the LH temperature blend door actuator electrical connector.
5. Remove the 2 LH temperature blend door actuator screws.
6. Remove the LH temperature blend door actuator.
7. To install, reverse the removal procedure.