F 250 2WD Super Duty V10-6.8L (2009)
-
Check for:
-
corrosion
-
damaged pins
-
pushed-out pins
-
Connect the APIM connector and make sure it seats correctly.
-
Verify the concern is still present.
-
Is the concern still present?
Yes
INSTALL a new APIM. CLEAR the DTCs. REPEAT the network test with the scan tool.
No
The system is operating correctly at this time. The concern may have been caused by a loose or corroded connector. CLEAR the DTCs. REPEAT the
network test with the scan tool.
-------------------------------------------------
T36 CHECK FOR CORRECT IC OPERATION
-
Disconnect the IC connector.
-
Check for:
-
corrosion
-
damaged pins
-
pushed-out pins
-
Connect the IC connector and make sure it seats correctly.
-
Operate the system and verify the concern is still present.
-
Is the concern still present?
Yes
INSTALL a new IC. CLEAR the DTCs. REPEAT the network test with the scan tool.
No
The system is operating correctly at this time. The concern may have been caused by a loose or corroded connector. CLEAR the DTCs. REPEAT the
network test with the scan tool.
-------------------------------------------------
T37 CHECK FOR CORRECT EVRT ACTUATOR OPERATION
-
Disconnect the EVRT actuator connector.
-
Check for:
-
corrosion
-
damaged pins
-
pushed-out pins
-
Connect the EVRT actuator and make sure it seats correctly.
-
Operate the system and verify the concern is still present.
-
Is the concern still present?
Yes
INSTALL a new EVRT actuator. CLEAR the DTCs. REPEAT the network test with the scan tool.
No
The system is operating correctly at this time. The concern may have been caused by a loose or corroded connector. CLEAR the DTCs. REPEAT the
network test with the scan tool.
-------------------------------------------------
T38 CHECK FOR CORRECT TCM OPERATION
-
Disconnect the TCM connector.
-
Check for:
-
corrosion
-
damaged pins