F 250 2WD Super Duty V10-6.8L (2009)
-
When installing, make sure the bushing between the D-ring and safety belt height adjuster is in place before installing the bolt.
4. Separate the rear door weatherstrip from around the rear door upper and lower trim panels.
5. Remove the rear door upper trim panel.
-
Pull outward to release the rear door upper trim panel clips.
6. Open the anchor cover. Remove the safety belt retractor and pretensioner belt anchor bolt and separate the anchor from the door.
-
To install, tighten to 40 Nm (30 lb-ft).
7. Lift up and remove the safety belt finish trim panel.
-
Route the safety belt through the safety belt finish trim panel opening.
8. Remove the rear door lower trim panel screws.
9. NOTICE: Do not pull directly outward on the rear door lower trim panel, as damage will occur.
Pull straight up to remove the rear door lower trim panel.
-
Route the safety belt through the lower rear door trim panel opening.
10. Disconnect the safety belt retractor and pretensioner electrical connector and remove the bolt.
-
To install, tighten to 40 Nm (30 lb-ft).
11. Slide the safety belt retractor and pretensioner up, tip the tab at the top out of the door and remove the safety belt retractor and pretensioner.
12. NOTE: Before installation, make sure the safety belt webbing is not twisted and the safety belts and buckles are accessible to the occupants.
To install, reverse the removal procedure.
13. Repower the SRS. For additional information, refer to Supplemental Restraint System (SRS) Depowering and Repowering in the General
Procedures portion of Air Bag Systems.
14. Check the active restraint system for correct operation. For additional information, refer to the appropriate Functional Test procedure in Safety
Belt System See: Testing and Inspection/Component Tests and General Diagnostics.
