F 250 2WD Super Duty V10-6.8L (2009)
1. Remove the power steering pump pulley. For additional information, refer to Power Steering Pump Pulley See: Power Steering Pump Pulley.
2. Release the clamp and disconnect the power steering pump supply hose.
3. Remove the pressure line bracket/pump bolt.
-
To install, tighten to 25 Nm (18 lb-ft).
4. Disconnect the pressure line-to-pump fitting.
-
Discard the Teflon(R) seal.
-
To install, tighten to 35 Nm (26 lb-ft).
5. Remove the 2 bolts and the power steering pump.
-
To install, tighten to 25 Nm (18 lb-ft).
6. NOTE: Make sure that the power steering pump bolts are installed in their original positions.
NOTE: Thoroughly clean all foreign material from the pressure line-to-pump threads before installing the fitting.
To install, reverse the removal procedure.
-
Using the Teflon(R) Seal Installer Set, install a new Teflon(R) seal on the pressure line fitting.
7. Fill the power steering system.
