F 250 2WD Super Duty V10-6.8L (2009)
8. NOTE: The transmission insulator studs may come out of the insulator when removing the nuts. Install new insulator studs if the studs comes out
of the insulator.
Install the transmission insulator bolts and nuts.
-
Tighten the transmission insulator studs to 75 Nm (55 lb-ft).
-
Tighten the transmission insulator-to-extension housing bolts to 103 Nm (76 lb-ft).
-
Tighten transmission insulator-to-crossmember nuts to 115 Nm (85 lb-ft).
9. Install the driveshaft.
10. Start the engine. Move the selector lever through all the gear ranges, checking for engagements.
11. With the vehicle in NEUTRAL, engine running and the transmission at normal operating temperature 66-77°C (150-170°F), check and adjust the
transmission fluid level, and check for any leaks. If fluid is needed, add fluid in increments of 0.24L (0.5 pt) until the correct level is achieved
(fluid should be in the hot range cross-hatched area of the fluid level indicator).
