F 250 2WD Super Duty V10-6.8L (2009)
Shifter A/T: Service and Repair
Selector Lever
Selector Lever
Selector Lever
Removal and Installation
1. Remove the lower steering column trim panel.
2. Remove the tilt lever dust boot.
3. Remove the screw and the tilt lever.
-
To install, tighten to 6 Nm (53 lb-in).
4. Remove the screws and the lower steering column shroud.
5. Remove the upper steering column shroud.
6. Disconnect the Transmission Control Switch (TCS) electrical connector.